|
Call Us Toll Free
1-800-305-8886







| |
Automatic
Garage Door Opener and Garage Door Safety & Maintenance Guide

Garage
Door System Safety - An Automatic Decision
A garage door is the largest moving object in the home. They are
often operated by electric door openers. Proper installation,
operation, and maintenance and testing are necessary to provide
safe, trouble-free operation. An improperly adjusted garage door
or automatic opener can exert deadly force when the door closes.
This could lead to serious injury or death from being hit by a
closing garage door or from being trapped under the door.
Safety is Everyone's Business
A few simple precautions can protect your family and friends
from potential harm. Please take a few minutes to read the
following safety and maintenance tipe. Refer to your garage door
and opener's manual for details specific to the model you own.
Then check the operation of your garage door and automatic
opener. |
|
Garage
Door Openers are not Toys
Do Not stand or walk under a moving door! Do not let
children or adults play "beat the door". It is dangerous and can
result in serious injury or death. Adults should set a good
example. Know how to use the emergency release, in case someone
is pinned by the door.
Do Not let children play with or use the transmitters or
remote controls. Always place and store them out of the reach of
children.
The pushbutton wall control should be out of the reach of
children (at least 5 feet from the floor) and away from all
moving parts. Mount and use the button where you can clearly see
the moving garage door.
|
Teach Your Children About Garage Door and Opener Safety
Garage door openers are not toys. Careless operation and
allowing children to play with or use garage door opener
controls can lead to tragic results. Discuss garage door
safety with your children. Explain the danger of being trapped
under the door.

When using the pushbutton or transmitter, keep the door in
sight until it completely stops moving. Teach children never
to play under or near an open garage door.
Teach children to keep their hands and fingers clear of
section joints, hinges, tracks, springs and other door parts.
Contact with a moving door or its hardware could cause serious
injury. These injuries can also happen with garage doors that
don't have automatic openers.
|
|
Routine Maintenance Can Prevent Tragedies
Take a few minutes to inspect and test your complete garage door
system. Make a monthly inspection and testing a part of your
regular routine. Safety is everyone's business. Make a garage door
and a garage door opener safety automatic in your home.
|
Monthly
Maintenance Checklist |
|
Garage
Door Opener
-
Reversal Test
-
Force
Setting Test
-
Additional Safety Devices
|
Garage Door
-
Visual
Inspection - Springs, Rollers, Pulleys, Cables, and
Track
-
Lubrication
-
Door
Balance
|
Consult owner's manual for additional recommended maintenance
for your models of door and opener. |
|
Testing
and Maintaining the Garage Door Opener
There are routine safety and maintenance steps that you should
follow once a month. Review your owner's manual for the door
opener. If you do not have an owners manual, look for the opener
model number on the back of the power unit and request a manual
from the manufacturer.
Reversal Test
Make sure your opener has a reversing feature. If a reversing
feature is not present, it should be replaced. Garage door
openers manufactured after
January 1, 1993
are required by federal law to have advanced safety features
which comply with the latest U.L. 325 standards: Contact your
manufacturer or installer for additional information.
Test
the reversing feature every month.
-
First, test
the balance of the door (see "Testing and Maintaining The
Garage Door."). If the door is properly balanced, then
proceed.
-
With the door
fully open, place a 1-1/2" thick piece of wood (a 2"x4" laid
flat) on the floor in the center of the door.
-
Push the
transmitter or wall button to close the door. The door must
reverse when it strikes the wood. (Note that the bottom part
of "one piece doors" must be rigid so that the door
will not close without reversing.)
-
If the door
does not have reverse, have it repaired or replaced. Have a
qualified individual adjust, repair or replace the opener or
door.
Force Setting Test
Test the force setting of your garage door opener by holding the
bottom of the door as it closes. If the door does not reverse
readily, the force may be excessive and need adjusting. See your
owners manual for details on how to make the adjustment. Test
the reversing feature after any adjustment.
Additional Safety Devices
Many garage door openers can be equipped with additional safety
devices. Consider adding a photo eye or edge sensor as an extra
measure of safety to prevent against entrapment. Keep in mind
that adding more safety devices will not make an old opener meet
current U.L. standards.
Make sure the additional safety devices, such as photo eyes or
edge sensors, are properly installed and adjusted (see owner's
manual). |
|
Testing and Maintaining the Garage Door
Perform routine maintenance steps once a month. Review your
owner's manual for the garage door. If you don't have a manual,
look for the model number on the back of the door, or check the
lock handle, hinges, or other hardware for the manufacturer's
name and request a manual from the manufacturer.
Visual Inspection
Look at the garage door springs, cables, rollers, pulleys, and
other door hardware for signs of wear. If you suspect problems,
have a qualified person make repairs.
Warning - Springs are under high tension. Only qualified
persons should adjust them
Garage door springs, cables, brackets, and other hardware
attached to the springs, are under very high tension and, if
handled improperly, can cause serious injury. Only a qualified
professional or a mechanically experienced person carefully
following the manufacturer's instructions should adjust them.
The torsion springs (the springs above the door) should only be
adjusted by a professional. Do not attempt to repair or adjust
the torsion springs yourself.
A restraining cable or other device should be installed on the
extension spring (the spring along the side of the door) to help
contain the spring if it breaks.
Never remove, adjust or loosen the screws on the bottom brackets
of the door. These brackets are connected to the spring by the
lift cable and are under extreme tension.
Lubrication
Regularly lubricate the moving parts of the door. However, do
not lubricate plastic parts such as plastic rollers and plastic
idler bearings. Consult the door owner's manual for the
manufacturer's recommendation.
Door Balance
Periodically test the balance of your door.
-
Start with
the door closed
-
If you have a
garage door opener, use the release mechanism so you can
operate the door by hand when doing this test
-
You should be
able to lift the door smoothly and with little resistance. It
should stay open around three or four feet above the floor. If
it does not, it is out of adjustment. Have it adjusted by a
qualified service person.
|
|
Garage Door Opener Safety - An Automatic Decision
This important information is provided by the U.S. Consumer
Product Safety Commission, the National Safety Counsel and the
Industry Coalition for Automatic Garage Door Opener Safety. |
Return to the Top of This Page
|
| |
|
|